Owners Manual

Figure 57. Removing and installing the control panel—NX3230
1.
screw (3) 2. control panel
3. hard-drive backplane 4. connector
5. plastic pull tab
Next steps
1. Replace the control panel. See Installing the Control Panel section in this document.
2. Complete the tasks listed in After working inside your system section in this document.
Related References
Safety instructions on page 46
Related tasks
Before working inside your system on page 47
After working inside your system on page 47
Installing the control panel on page 114
Installing the control panel
Prerequisites
1. Ensure that you read the Safety instructions section in this document.
2. Keep the T15 Torx screw driver handy.
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow
the safety instructions that are shipped with your product.
114 Installing and removing system components