Owners Manual

Figure 37. Removing the NDC
1.
captive screw socket (2) 2. connector on the system board
3. captive screw (2) 4. touch point (2)
5. network daughter card (NDC) 6. back panel slot for Ethernet connectors
Next steps
1. Install the NDC.
2. If removed, install the expansion card riser 1.
3. Follow the procedure listed in the After working inside your system section.
Related References
Safety instructions on page 46
Related tasks
Before working inside your system on page 47
After working inside your system on page 47
Installing the network daughter card
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. If applicable, remove the expansion card riser 1.
4. Keep the Phillips #1 screwdriver ready.
88
Installing and removing system components