Setup Guide

Part Part Number Description

Used to secure the tray rails to a rack, regardless of

the rack type

036-034-003

Square hole alignment pin (Quantity: 9)

Replacement alignment pin used to mount tray rails in

racks that have 0.375 in. square holes

036-034-004

Threaded hole alignment pin (Quantity: 9)

Replacement alignment pin used to mount tray rails in

racks that have threaded holes

Mount the Cable Management Tray

If you plan to use the 1U cable management tray, mount the tray before mounting the

SC460 expansion enclosure.

Prerequisite

Required materials:

• Screwdriver (034-000-193)

• Four 8-32 x 0.75 in. knurled head Phillips screws (036-034-012)

• Left 1U cable management tray rail (042-034-012)

• Right 1U cable management tray rail (042-034-008)

• 1U cable management tray (042-033-060)

Steps

1 Adjust the length of the 1U cable management tray rails (042-034-012 and

042-034-008) to t the rack.

2 Align the rails so that the UP arrow is pointed in the correct direction and the side of

the rail labeled FRONT is at the front of the rack.

3 Insert the alignment pins of left and right rails into the mounting holes at the front and

back of the rack.

4 Secure the rails by installing 8-32 x 0.75 in. screws (036-034-012) into the holes at the

front and back of the rails.

Setting Up the Expansion Enclosure