Administrator Guide

6 Click OK.
The Edit Port dialog box closes.
Grouping Fibre Channel I/O Ports Using Fault
Domains
Front-end ports are categorized into fault domains that identify allowed port movement when a controller reboots or a port fails. Ports that
belong to the same fault domain can fail over to each other because they have connectivity to the same resources.
NOTE: Fault domains cannot be added or modied on SCv2000 or SCv3000 series storage systems. Storage Center creates and
manages fault domains on these systems.
Create a Fibre Channel Fault Domain
Create a Fibre Channel fault domain to group Fibre Channel ports for failover purposes.
Prerequisites
The Fibre Channel ports to add to the fault domain must be uncongured. Ports that are already added to a fault domain or designated as
back-end ports cannot be added to a new fault domain.
• In virtual port mode, all Fibre Channel ports that are connected to the same Fibre Channel fabric should be added to the same fault
domain.
• In legacy mode, each pair of primary and reserved ports connected to the same Fibre Channel fabric should be added to a unique fault
domain. The primary port should be located on a dierent controller than the secondary port.
About this task
NOTE
: Fibre Channel ports are always congured in Virtual Port Mode on SCv2000 and SCv3000 series storage systems.
Legacy Mode is not supported.
Steps
1 If you are connected to a Data Collector, select a Storage Center from the drop-down list in the left navigation pane.
2 From the SYSTEM menu, select Ports.
The Ports view is displayed.
3 Click the Front End Ports tab and select Fibre Channel.
4 Click (New) and select Create Fibre Channel Fault Domain.
The Create Fault Domain dialog box opens.
5 In the Name eld, type a name for the fault domain.
6 In the Ports table, select the Fibre Channel ports to add to the fault domain. All Fibre Channel ports in the fault domain should be
connected to the same Fibre Channel fabric
7 Click OK.
Rename a Fibre Channel Fault Domain
The fault domain name allows administrators to identify the fault domain.
1 If you are connected to a Data Collector, select a Storage Center from the drop-down list in the left navigation pane.
2 From the SYSTEM menu, select Ports.
The Ports view is displayed.
3 Click the Front End Ports tab.
4 Expand Fibre Channel and click the fault domain link.
The Fault Domain view is displayed.
140
Storage Center Maintenance