Administrator Guide
The Disks view is displayed.
5 In the right pane, select a disk and click Toggle Indicator.
The Toggle Indicator dialog box opens.
6 Click OK.
Clear the Swap Status for a Disk
Clear the swap status for a disk to acknowledge that it has been replaced.
1 If you are connected to a Data Collector, select a Storage Center from the drop-down list in the left navigation pane.
2 From the SYSTEM menu, select Hardware.
The Hardware view is displayed.
3 Click the System tab.
4 In the System tab navigation pane, click Disks.
The Disks view is displayed.
5 In the right pane, select a disk, then click Request Swap Clear.
Managing Storage Center Controllers
Unisphere can help you manage and maintain the controllers in your Storage Center by walking you through the process for adding a
controller and replacing parts.
Add a Controller
This step-by-step wizard guides you through adding a new controller to the storage system.
Prerequisites
• This wizard is only available for SC4020, SC8000, and SC9000 controllers.
• The new controller must have a Hardware Serial Number (HSN) and Eth 1 IP address assigned to it before starting this procedure. To
see the new controller information, run the following command from the serial console:
controller show
Steps
1 If you are connected to a Data Collector, select a Storage Center from the drop-down list in the left navigation pane.
2 From the SYSTEM menu, select Hardware.
The Hardware view is displayed.
3 Click the System tab.
4 In the System tab navigation pane, click Controllers.
The Controllers view is displayed.
5 Click Add Controller.
The Add New Controller wizard opens.
6 Conrm the details of your current install, and click Next.
7 Insert the controller into the existing enclosure. Click Next to validate the install.
8 Click Finish to exit the wizard.
172
Storage Center Maintenance