Administrator Guide

The Data Collector Restart dialog box opens.
5 Click Yes.
The Data Collector service stops and restarts.
Enable the Chargeback Feature
To enable the Chargeback feature, add a Chargeback license le or product key to the Data Collector.
1 If a Storage Center is selected from the drop-down list, click (Home) in the left navigation pane.
2
Click Data Collector.
The Data Collector view is displayed.
3 Click the General tab, and then click the Summary subtab.
4 In the License Information section, click Submit License.
The License information dialog box opens.
5 To enable the Chargeback feature using a license le:
a Select the License File (*.lic) radio button.
b Click Browse and navigate to the location of the license le.
c Select the license le and click Open
d Click OK.
6 To enable the Chargeback feature using a product key:
a Select the Product Key radio button.
b Type the product key in the Product Key eld.
c Click OK.
Change Storage Center Timeout Settings
Use the Edit Advanced Settings to set Storage Center timeout values.
About this task
NOTE
: The Data Collector must be restarted to apply timeout setting changes.
Steps
1 If a Storage Center is selected from the drop-down list, click (Home) in the left navigation pane.
2 Click Data Collector.
The Data Collector view is displayed.
3 Click the General tab, and then click the Summary subtab.
4 Expand the Advanced area located below the License Information section.
5 Click Edit.
The Edit Advanced Settings dialog box opens.
6 Set the timeout and delay settings as needed:
• Storage Center Connection Timeout – Maximum time that the Storage Center waits for a response for queries sent to the Data
Collector.
• Storage Center Connection Delay – Maximum time that the Storage Center waits to successfully connect to the Data Collector.
• Storage Center Ping Timeout – Maximum time that the Storage Center waits for a response to a ping command to the Data
Collector.
• Storage Center Read Timeout – Maximum time that the Storage Center waits while attempting read data from the Data
Collector.
7 Click OK.
The Data Collector Restart dialog box opens.
202
Data Collector Management