Administrator Guide
6 Click OK.
Assign a Dierent Storage Prole to Multiple Volumes
The storage prole determines the RAID type and storage tiers used by the volume. A storage prole can be assigned to multiple volumes in
one operation.
1 If you are connected to a Data Collector, select a Storage Center from the drop-down list in the left navigation pane.
2 From the STORAGE menu, select Volumes.
The Volumes view is displayed.
3 In the Volumes view, select the volumes you want to modify.
• To select contiguous volumes, select the rst volume, then hold down Shift and select the last volume.
• To select individual volumes, hold down Control while selecting them.
4 Click (More Actions) and select Set Storage Prole.
The Set Storage Prole dialog box opens.
5 From the Storage Prole drop-down menu, select a storage prole.
6 Click OK.
Force Writes to the Lowest Storage Tier for a Volume
The Import to lowest tier option forces all data written to the volume to the lowest storage tier congured for the volume. This option is
typically used when importing data to a new volume from an external source. New writes to the volume from a host after the import is
complete will follow the Storage Prole for the volume. It is important to change the Storage Prole once the import is complete to avoid
potential performance degradation by writing to the lowest tier of drives.
Prerequisite
The volume must use a standard storage type. The Import to lowest tier option is not available for ash-optimized storage types.
Steps
1 If you are connected to a Data Collector, select a Storage Center from the drop-down list in the left navigation pane.
2
From the STORAGE menu, select Volumes.
The Volumes view is displayed.
3 In the Volumes view, select the volume you want to modify.
4 Click (Edit).
The Edit Volume dialog box opens.
5 Select the Import to lowest tier checkbox.
6 Click OK to close the Edit Volume dialog box.
Congure a Space Consumption Limit for a Volume
Set a space consumption limit to specify the maximum space that can be used on the volume. This option is not available for SCv2000 or
SCv3000 series controllers.
1 If you are connected to a Data Collector, select a Storage Center from the drop-down list in the left navigation pane.
2
From the STORAGE menu, select Volumes.
The Volumes view is displayed.
3 In the Volumes view, select the volume you want to modify.
4 Click (Edit).
The Edit Volume dialog box opens.
46
Storage Center Administration