Administrator Guide

4. In the right pane, select the cooling fan, then click Request Swap Clear.
Clear the Swap Status for an Enclosure IO Module
Clear the swap status for an enclosure IO module to acknowledge that it has been replaced.
1. Select a Storage Center from the Storage view. (Data Collector connected Storage Manager Client only)
2. Click the Hardware tab.
3. In the Hardware tab navigation pane, select I/O Modules.
4. In the right pane, select the IO module, then click Request Swap Clear.
Clear the Swap Status for an Enclosure Power Supply
Clear the swap status for an enclosure power supply to acknowledge that it has been replaced.
1. Select a Storage Center from the Storage view. (Data Collector connected Storage Manager Client only)
2. Click the Hardware tab.
3. In the Hardware tab navigation pane, select Power Supplies.
4. In the right pane, select the power supply, then click Request Swap Clear.
Replace a Failed Power Supply
This step-by-step wizard guides you through replacing a failed power supply in an enclosure in the Storage Center.
Prerequisite
This wizard is only available for the SCv2000 series, and can be completed without a controller outage.
Steps
1. Select a Storage Center from the Storage view. (Data Collector connected Storage Manager Client only)
2. Expand Enclosures in the navigation pane. Select the enclosure with the failed power supply, then select Power Supply.
3. Click Replace Power Supply.
The Replace Failed Power Supply wizard appears.
4. Refer to the graphic in the wizard to locate the failed power supply. Click Next.
5. Follow the instructions to remove the failed power supply. Click Next.
6. Follow the instructions to insert the replacement power supply. Click Next to verify the replacement.
If this verication fails, an error message appears. You can proceed to the next step once the error is corrected and validated.
7. Click Finish to exit the wizard.
Clear the Under Voltage Status for a Power Supply
Clear the under voltage status for an enclosure power supply to acknowledge that you are aware of it.
1. Select a Storage Center from the Storage view. (Data Collector connected Storage Manager Client only)
2. Click the Hardware tab.
3. In the Hardware tab navigation pane, select Power Supplies.
4. In the right pane, select the power supply, then click Request DC Undervoltage Clear.
Clear the Swap Status for a Temperature Sensor
The swap status for a temperature sensor is set when the component that contains the sensor is replaced.
1. Select a Storage Center from the Storage view. (Data Collector connected Storage Manager Client only)
2. Click the Hardware tab.
3. In the Hardware tab navigation pane, select Temperature Sensors.
4. In the right pane, right-click the sensor, then click Request Swap Clear.
294
Storage Center Maintenance