Administrator Guide

• SCv2080

• SC4020

Steps

1. Configure the fault domain and ports (embedded fault domain 1 or Flex Port Domain 1).

NOTE: The Flex Port feature allows both Storage Center system management traffic and iSCSI traffic to use the

same physical network ports. However, for environments where the Storage Center system management ports are

mixed with network traffic from other devices, separate the iSCSI traffic from management traffic using VLANs.

a) Enter the target IPv4 address, subnet mask, and gateway for the fault domain.

b) Enter an IPv4 address for each port in the fault domain.

NOTE: Make sure that all the IP addresses for the fault domain are in the same subnet.

2. Configure the fault domain and ports (embedded fault domain 2 or Flex Port Domain 2).

a) Enter the target IPv4 address, subnet mask, and gateway for the fault domain.

b) Enter an IPv4 address for each port in the fault domain.

NOTE: Make sure that all the IP addresses for the fault domain are in the same subnet.

3. Click OK.

Discover and Configure Uninitialized SCv3000

Series Storage Systems

Use the Discover and Configure Uninitialized Storage Centers wizard to find and configure new SCv3000 Series storage systems. The

wizard helps set up a Storage Center to make it ready for volume creation.

NOTE: Make sure that you are running the latest version of the Dell Storage Manager Client.

Open the Discover and Configure Uninitialized Storage

Centers Wizard From the Storage Manager Client

Welcome Screen

Open the wizard directly from the welcome screen to discover and configure a Storage Center.

Prerequisites

• Client must be running on a system with a 64-bit operating system.

• The Storage Manager Client must be run using Windows Administrator privileges.

Steps

1. Open the Storage Manager Client welcome screen.

2. Click Discover and Configure Uninitialized Storage Centers.

The Discover and Configure Uninitialized Storage Centers wizard opens.

Open the Discover and Configure Uninitialized Storage

Centers Wizard from the Storage Manager Client

Open the wizard from the Storage Manager Client to discover and configure a Storage Center.

Prerequisites

• The Storage Manager Client must be running on a system with a 64-bit operating system.

• The Storage Manager Client must be run using Windows Administrator privileges.

Storage Center Deployment