Administrator Guide

3. Enter network information for the fault domain and its ports.

NOTE: Make sure that all the IP addresses for iSCSI Fault Domain 1 are in the same subnet.

4. Click Next.

5. On the Set IPv4 Addresses for iSCSI Fault Domain 2 page, enter network information for the fault domain and its ports. Then click

Next.

NOTE: Make sure that all the IP addresses for iSCSI Fault Domain 2 are in the same subnet.

6. Click Next.

7. Review the fault domain information.

8. (Optional) Click Copy to clipboard to copy the fault domain information.

9. (Optional) Review the information on the Hardware and Cabling Diagram tabs.

10. Click Next.

Configure SAS Ports

For a Storage Center with SAS front-end ports, the Review Fault Domains page displays information about the fault domains that were

created by the Storage Center.

Prerequisites

• One port from each controller within the same fault domain must be cabled.

• The ports for each fault domain must be cabled to the same server.

Steps

1. Review the information on the SAS - Cable Ports page. If the Storage Center is not cabled correctly to create fault domains, fix the

cabling and click Refresh.

2. Click Next.

The SAS – Review Fault Domains page opens.

3. Review the fault domains that have been created.

4. (Optional) Click Copy to clipboard to copy the fault domain information.

5. (Optional) Review the information on the Hardware and Cabling Diagram tabs.

6. Click Next.

Inherit Settings

Use the Inherit Settings page to copy settings from a Storage Center that is already configured.

Prerequisites

You must be connected through a Data Collector.

Steps

1. Select the Storage Center from which to copy settings.

2. Place a check next to each setting that you want to inherit, or click Select All to inherit all settings.

3. Click Next.

If you chose to inherit time and SMTP settings from another Storage Center, the Time Settings and SMTP Server Settings pages

are skipped in the wizard.

Configure Time Settings

Configure an NTP server to set the time automatically, or set the time and date manually.

Steps

1. From the Region and Time Zone drop-down menus, select the region and time zone used to set the time.

Storage Center Deployment