Administrator Guide
3 Click Next.
Complete Conguration and Perform Next Steps
The Storage Center is now congured. The Conguration Complete page provides links to a Storage Manager Client tutorial and wizards to
perform the next setup tasks.
1 (Optional) Click one of the Next Steps to congure a localhost, congure a VMware host, or create a volume.
When you have completed the step, you are returned to the Conguration Complete page. After you nish the Next Steps, continue
to Step 2.
2 Click Finish to exit the wizard.
Related links
Create a Server from the localhost
Create a Server from a VMware vSphere Host
Create a Server from a VMware vCenter Host
Creating Volumes
Congure Embedded iSCSI Ports
Congure the embedded Ethernet ports on the Storage Center for use as iSCSI ports.
Prerequisites
The storage system must be one of the following:
• SCv2000
• SCv2020
• SCv2080
• SC4020
Steps
1 Congure the fault domain and ports (embedded fault domain 1 or Flex Port Domain 1).
NOTE
: The Flex Port feature allows both Storage Center system management trac and iSCSI trac to use the same
physical network ports. However, for environments where the Storage Center system management ports are mixed with
network trac from other devices, separate the iSCSI trac from management trac using VLANs.
a Enter the target IPv4 address, subnet mask, and gateway for the fault domain.
b Enter an IPv4 address for each port in the fault domain.
NOTE
: Make sure that all the IP addresses for the fault domain are in the same subnet.
2 Congure the fault domain and ports (embedded fault domain 2 or Flex Port Domain 2).
a Enter the target IPv4 address, subnet mask, and gateway for the fault domain.
b Enter an IPv4 address for each port in the fault domain.
NOTE
: Make sure that all the IP addresses for the fault domain are in the same subnet.
3 Click OK.
68
Storage Center Deployment