Administrator Guide

7. Follow the directions to disconnect the A side chain cables connecting the enclosure to the Storage Center. Click Next.
8. Reconnect the A side chain cables by following the directions to exclude the enclosure. Click Next.
9. Follow the directions to disconnect the B side chain cables connecting the enclosure to the Storage Center. Click Next.
10. Reconnect the B side chain cables by following the directions to exclude the enclosure. Click Next to validate the cabling and
delete the enclosure.
If the cabling is invalid, an error message appears. You can proceed to the next step once the error is corrected and validated.
11. Click Finish to exit the wizard.
Replace an Enclosure
The Replace Enclosure wizard guides you through replacing an enclosure in the storage system.
Prerequisites
• Requires a controller outage
• Available only for the SCv2000 series controller
• Available only if data has been released from all disks in the selected enclosure and the situation allows the replacement of an
enclosure
Steps
1. Select a Storage Center from the Storage view. (Data Collector connected Storage Manager Client only)
2. Click the Hardware view.
3. Expand Enclosures in the navigation pane. Select the enclosure you want to replace.
4. Click Replace Enclosure.
The Replace Enclosure wizard appears.
5. Click Next to accept the warning of service interruption.
6. Follow the instruction for locating the enclosure in the rack.
7. Click Next.
8. Follow all instructions to remove disks from the enclosure.
9. Click Next.
10. Disconnect the enclosure from the Storage Center.
11. Click Next.
12. Add disks to your enclosure by following the instructions.
13. Click Next.
14. Follow the instructions to connect the A-side chain.
15. Click Next.
The wizard checks that the enclosure is connected.
16. Follow the instructions to connect the B-side chain.
17. Click Next.
The wizard validates the cabling.
18. Click Finish to exit the wizard.
Rename a Disk Enclosure
Change the display name of a disk enclosure to dierentiate it from other disk enclosures.
1. Select a Storage Center from the Storage view. (Data Collector connected Storage Manager Client only)
2. Click the Hardware tab.
3. In the Hardware tab navigation pane, select an enclosure.
4. In the right pane, click Edit Settings. The Edit Settings dialog box appears.
5. In the Name eld, type a new name for the enclosure.
6. Click OK.
292
Storage Center Maintenance