Administrator Guide

6. In the Default Gateway IPv n Address eld, type the gateway IP address through which to access the subnet (for example,
192.0.2.25).
7. Click OK.
Delete a Static Route
Delete a static route to send trac for a subnet through the default gateway instead of a specic gateway.
1. In the Storage view, select a FluidFS cluster.
2. Click the File System tab.
3. In the File System view, select Cluster Connectivity.
4. Click the Client Network tab.
5. In the Static Route panel, click Delete Default Gateway. The Delete Default Gateway dialog box opens.
6. Click OK.
Managing the Client Networks
The client networks dene the client VIPs through which clients access SMB shares and NFS exports. To ensure eective load
balancing, use the following recommendations to determine the number of client VIPs to dene:
• If client access to the FluidFS cluster is not through a router (in other words, a at network), dene one client VIP per FluidFS
cluster.
• If clients access the FluidFS cluster through a router, dene a client VIP for each client interface port per NAS controller.
Related link
LAN/Client Network
LAN/Client Network
View the Client Networks
View the current client networks.
1. In the Storage view, select a FluidFS cluster.
2. Click the File System tab.
3. In the File System view, select Cluster Connectivity.
4. Click the Client Network tab. The Client Network panel displays the client networks.
Create a Client Network
Create a client network on which clients will access SMB shares and NFS exports.
1. In the Storage view, select a FluidFS cluster.
2. Click the File System tab.
3. In the File System view, select Cluster Connectivity.
4. Click the Client Network tab.
5. In the Client Network panel, click Create Client Network. The Create Client Network dialog box opens.
6. In the Netmask or Prex Length eld, type a netmask or prex for the client network.
7. In the VLAN Tag eld, type a VLAN tag.
When a VLAN spans multiple switches, the VLAN tag species which ports and interfaces to send broadcast packets to.
8. Add an IP address for each NAS controller:
a. Select a NAS controller and click Edit Settings. The Edit Controller IP Address dialog box opens.
b. In the IP Address eld, type an IP address for the NAS controller.
c. Click OK.
d. Repeat these steps for each NAS controller.
366
FluidFS Networking