Administrator Guide

Change the Netmask or Prex for the Secured Management Subnet
Change the netmask (IPv4) or prex (IPv6) for the secured management subnet.
1. Click the Storage view and select a FluidFS cluster.
2. Click the File System tab.
3. In the File System panel, expand Environment, select Network, and then click the Management Network tab.
4. In the right pane, click Edit Settings. The Edit Management Network Settings dialog box appears.
5. In the Netmask or Prex Length eld, type a netmask or prex for the secured management subnet.
6. Click OK.
Change the VLAN Tag for the Secured Management Subnet
When a VLAN spans multiple switches, the VLAN tag is used to specify which ports and interfaces to send broadcast packets to.
1. Click the Storage view and select a FluidFS cluster.
2. Click the File System tab.
3. In the File System panel, expand Environment, select Network, and then click the Management Network tab.
4. In the right pane, click Edit Settings. The Edit Management Network Settings dialog box appears.
5. In the VLAN Tag eld, type a VLAN tag for the secured management subnet.
6. Click OK.
Change the VIPs for the Secured Management Subnet
Change the secured management subnet VIPs through which the administrator manages the FluidFS cluster.
1. Click the Storage view and select a FluidFS cluster.
2. Click the File System tab.
3. In the File System panel, expand Environment, select Network, and then click the Management Network tab.
4. In the right pane, click Edit Settings. The Edit Management Network Settings dialog box appears.
5. To add a management VIP:
a. In the Virtual IP Addresses area, click Add. The Add Client IP Address dialog box appears.
b. In the IP Address eld, type a management VIP IP address.
c. Click OK.
6. To remove a management VIP:
a. Select a management VIP.
b. Click Remove.
NOTE: A secured management subnet must have at least one management VIP.
7. Click OK.
Change the NAS Controller IP Addresses for the Secured Management Subnet
To change the NAS controller IP addresses for the secured management subnet, for example, if you go from an unsecured to a
secured environment, or you physically relocate your equipment:
1. Click the Storage view and select a FluidFS cluster.
2. Click the File System tab.
3. In the File System panel, expand Environment, select Network, and then click the Management Network tab.
4. In the right pane, click Edit Settings. The Edit Management Network Settings dialog box appears.
5. Select a NAS controller and click Edit Settings. The Edit Controller IP Address dialog box appears.
6. In the IP Address eld, type an IP address for the NAS controller.
7. Click OK to close the Edit Controller IP Address dialog box.
FluidFS System Management for FS Series Appliances
515