Administrator Guide

Either the Enclosure or Controller view is displayed.
4. Under the selected enclosure or controller, click Fan Sensors.
The Fan Sensors view is displayed.
5. In the right pane. select the failed sensor and click Replace Failed Cooling Fan Sensor.
The Replace Failed Cooling Fan Sensor wizard opens.
6. Refer to the graphic in the wizard to locate the failed cooling fan sensor. Click Next.
7. Follow the instructions to remove the power supply from the enclosure. Click Next.
8. Follow the instructions to insert the replacement power supply. Click Next to verify the replacement.
If this verification fails, an error message is displayed. You can proceed to the next step once the error is corrected and validated.
9. Click Finish to exit the wizard.
Enable or Disable the Disk Indicator Light
The drive bay indicator light identifies a drive bay so it can be easily located in an enclosure.
Steps
1. If the Storage Manager Client is connected to a Data Collector, select a Storage Center from the Storage view.
2. Click the Hardware tab.
3. In the Hardware tab navigation pane, expand Enclosures, then select and expand an enclosure.
The Enclosure view is displayed.
4. Under the selected enclosure, click Disks.
The Disks view is displayed.
5. In the right pane, click the Disks subtab and select a disk.
6. Enable or disable the disk indicator light for the selected disk.
• If the indicator light is off, click Indicator On to enable the indicator light.
• If the indicator light is on, click Indicator Off to disable the indicator light.
Clear the Swap Status for a Disk
Clear the swap status for a disk to acknowledge that it has been replaced.
Steps
1. If the Storage Manager Client is connected to a Data Collector, select a Storage Center from the Storage view.
2. Click the Hardware tab.
3. In the Hardware tab navigation pane, expand Enclosures, then select and expand an enclosure.
The Enclosure view is displayed.
4. Under the selected enclosure, click Disks.
The Disks view is displayed.
5. In the right pane, click the Disks subtab, select a disk, then click Request Swap Clear.
Managing Storage Center Controllers
Storage Manager can help you manage and maintain the controllers in your Storage Center by walking you through the process for adding
a controller and replacing parts.
Add a Controller
This step-by-step wizard guides you through adding a new controller to the storage system.
Prerequisites
• This wizard is only available for SC4020, SC8000, and SC9000 controllers.
278
Storage Center Maintenance