Administrator Guide

Replace an Enclosure
The Replace Enclosure wizard guides you through replacing an enclosure in the storage system.
Prerequisites
• Requires a controller outage
• Available only for the SCv2000 series controller
• Available only if data has been released from all disks in the selected enclosure and the situation allows the replacement of an enclosure
Steps
1 If the Storage Manager Client is connected to a Data Collector, select a Storage Center from the Storage view.
2 Click the Hardware tab.
3 In the Hardware tab navigation pane, click Enclosure.
The Enclosure view is displayed.
4 Select the enclosure you want to replace and click Replace Enclosure.
The Replace Enclosure wizard opens.
5 Click Next to accept the warning of service interruption.
6 Follow the instruction for locating the enclosure in the rack.
7 Click Next.
8 Follow all instructions to remove disks from the enclosure.
9 Click Next.
10 Disconnect the enclosure from the Storage Center.
11 Click Next.
12 Add disks to your enclosure by following the instructions.
13 Click Next.
14 Follow the instructions to connect the A-side chain.
15 Click Next.
The wizard checks that the enclosure is connected.
16 Follow the instructions to connect the B-side chain.
17 Click Next.
The wizard validates the cabling.
18 Click Finish to exit the wizard.
Rename a Disk Enclosure
Change the display name of a disk enclosure to dierentiate it from other disk enclosures.
1 If the Storage Manager Client is connected to a Data Collector, select a Storage Center from the Storage view.
2 Click the Hardware tab.
3 In the Hardware tab navigation pane, expand Enclosure, then select an enclosure.
The Enclosure view is displayed.
4 In the right pane, click Edit Settings.
The Edit Settings dialog box opens.
5 In the Name eld, type a new name for the enclosure.
6 Click OK.
Storage Center Maintenance
299