Administrator Guide

a Select a NAS controller and click Edit Settings.
The Edit Controller IP Address dialog box opens.
b In the IP Address eld, type an IP address for the NAS controller.
c Click OK.
d Repeat the preceding steps for each NAS controller.
e To specify a VLAN tag, type a VLAN tag in the VLAN Tag eld.
When a VLAN spans multiple switches, the VLAN tag is used to specify to which ports and interfaces to send broadcast
packets.
f Click Next.
8 To verify connectivity between the FluidFS cluster and the Storage Center, use the Connectivity Report page. The NAS controller
ports must show the status as Up before you can complete the wizard. If you click Finish and the NAS controller ports do not have
the Up status, an error will be displayed.
• (iSCSI NAS appliances) When the Connectivity Report initially appears, iSCSI logins might still be occurring in the background,
causing some or all of the FluidFS cluster iSCSI initiators to show the status Not Found/Disconnected. If you see this status,
wait 30 seconds, then click Refresh to update the Connectivity Report. When the iSCSI logins are complete and the Connectivity
Report has been refreshed, the status for each FluidFS cluster iSCSI initiator shows as Up.
• (Fibre Channel NAS appliances) When the Connectivity Report initially appears, the FluidFS cluster HBAs show the status Not
Found/Disconnected. You must record the WWNs and manually update fabric zoning on the Fibre Channel switch. Then, click
Refresh to update the Connectivity Report. When the zoning is congured correctly and the Connectivity Report has been
refreshed, the status for each FluidFS cluster HBA shows as Up.
9 Click Finish.
NOTE: The Storage Center that was just added is not providing storage space to the FluidFS cluster yet. After adding a
Storage Center, you must expand the NAS pool to get the new Storage Center to provide block-level storage for the NAS
pool.
10 Expand the NAS pool.
When the expand NAS pool process is complete, the Storage Center tab will display both Storage Centers and the Volume Status
should show as Up.
Adding and Deleting NAS Appliances in a FluidFS Cluster
FluidFS supports up to four NAS appliances for each FluidFS cluster.
Add NAS Appliances to a FluidFS Cluster
You can add a NAS appliance (two NAS controllers) to a FluidFS cluster to increase processing power. Adding a NAS appliance allows
additional client connections and evenly redistributes client connections and FluidFS cluster operations among more NAS controllers
contributing their resources.
Prerequisites
• The additional NAS appliance is mounted in a rack and cabled, and the NAS controllers are in standby mode and powered on. A NAS
controller is on and in standby mode if the power LED is ashing green at around two ashes per second.
• NAS appliance service tags are recorded.
• New client VIP IP addresses are available to be added to the new NAS appliance. To ensure eective load balancing, use the following
recommendations to determine the number of client VIPs to dene:
– If client access to the FluidFS cluster is not through a router (in other words, a at network), dene one client VIP per FluidFS
cluster.
– If clients access the FluidFS cluster through a router, dene a client VIP for each client interface port per NAS controller.
• New NAS controller IP addresses are available to be added to the new NAS appliance. Verify that there are two additional IP addresses
available per NAS appliance.
About this task
For high availability reasons, you must add NAS appliances as NAS controller pairs. You cannot add a single NAS controller. Only one NAS
appliance can be added at a time up to a maximum of four NAS appliances (eight NAS controllers).
FluidFS Administration
479