Administrator Guide

a Type the hostname or IP address of the Primary Data Collector in the Server eld.
b In the Web Server Port eld, type the port number of the Primary Data Collector web service.
The default port is 3033.
c Type the user name of the administrator user on the Primary Data Collector in the User Name eld.
d Type the password of the administrator user on the Primary Data Collector in the Password eld.
e Select a time zone for the Primary Data Collector from the Timezone drop-down menu.
6 Click Next.
The Ports page appears.
7 To change the port number of a service or enable/disable a service:
a Select the service to modify and click Edit.
The Edit Port dialog box open.
b To change the port number of the service, type a dierent port number in the Port eld.
c To enable or disable the service, select or clear the Enabled check box.
d Click OK.
8 Click Next.
The Summary page appears.
9 Verify the information on the Summary page.
10 Click Finish.
A conrmation dialog box is displayed.
11 Click Yes.
After the Remote Data Collector setup is complete, the Data Collector restarts, and the login page for Unisphere Central is displayed.
Disconnecting and Reconnecting a Remote Data
Collector
Perform these tasks to disconnect or reconnect a remote Data Collector.
NOTE
: For user interface reference information, click Help.
Temporarily Disconnect a Remote Data Collector
Stop the Data Collector service on the remote Data Collector to temporarily disconnect it from the primary Data Collector.
1 On the remote Data Collector server:
a Open the Data Collector.
b On the General Information tab, click Stop to stop the Data Collector service.
2 Use the Storage Manager Client to connect to the primary Data Collector and log on.
3 Click the Replications & Live Volumes view, then click the Remote Data Collector tab.
The Connection Status of the remote Data Collector shows Down the next time the primary Data Collector attempts to synchronize
with the remote Data Collector.
Reconnect a Remote Data Collector to a Storage Center
If the remote Data Collector loses connectivity to a Storage Center, make sure that the remote Data Collector is using the correct host
name or IP address for the Storage Center.
1 Use the Storage Manager Client to connect to the remote Data Collector.
2 On the Primary Data Collector tab, locate the down Storage Center, then click Reconnect to Storage Center. The Reconnect to
Storage Center dialog box appears.
Remote Data Collector
589