Administrator Guide

3 Click Next.

Complete Conguration and Perform Next Steps

The Storage Center is now congured. The Conguration Complete page provides links to a Storage Manager Client tutorial and wizards to

perform the next setup tasks.

1 (Optional) Click one of the Next Steps to congure a localhost, congure a VMware host, or create a volume.

When you have completed the step, you are returned to the Conguration Complete page. After you nish the Next Steps, continue

to Step 2.

2 Click Finish to exit the wizard.

Related links

Create a Server from the localhost

Create a Server from a VMware vSphere Host

Create a Server from a VMware vCenter Host

Creating Volumes

Congure Embedded iSCSI Ports

Congure the embedded Ethernet ports on the Storage Center for use as iSCSI ports.

Prerequisites

The storage system must be one of the following:

• SCv2000

• SCv2020

• SCv2080

• SC4020

Steps

1 Congure the fault domain and ports (embedded fault domain 1 or Flex Port Domain 1).

NOTE

: The Flex Port feature allows both Storage Center system management trac and iSCSI trac to use the same

physical network ports. However, for environments where the Storage Center system management ports are mixed with

network trac from other devices, separate the iSCSI trac from management trac using VLANs.

a Enter the target IPv4 address, subnet mask, and gateway for the fault domain.

b Enter an IPv4 address for each port in the fault domain.

NOTE

: Make sure that all the IP addresses for the fault domain are in the same subnet.

2 Congure the fault domain and ports (embedded fault domain 2 or Flex Port Domain 2).

a Enter the target IPv4 address, subnet mask, and gateway for the fault domain.

b Enter an IPv4 address for each port in the fault domain.

NOTE

: Make sure that all the IP addresses for the fault domain are in the same subnet.

3 Click OK.

Storage Center Deployment