Deployment Guide

• Use only Dell-supported SFP+ transceiver modules with the SCv2000/SCv2020. Other generic SFP+ transceiver modules are

not supported and may not work with the SCv2000/SCv2020.

• The SFP+ transceiver module housing has an integral guide key that is designed to prevent you from inserting the transceiver

module incorrectly.

• Use minimal pressure when inserting an SFP+ transceiver module into an FC port. Forcing the SFP+ transceiver module into a

port may damage the transceiver module or the port.

• The SFP+ transceiver module must be installed into a port before you connect the fiber-optic cable.

• The fiber-optic cable must be removed from the SFP+ transceiver module before you remove the transceiver module from the

port.

Install an SFP+ Transceiver Module

Complete the following steps to install an SFP+ transceiver module in a 16 Gb FC storage controller.

About this task

Read the following cautions and information before installing an SFP+ transceiver module.

WARNING: To reduce the risk of injury from laser radiation or damage to the equipment, observe the following

precautions:

• Do not open any panels, operate controls, make adjustments, or perform procedures to a laser device other than those

specified in this document.

• Do not stare into the laser beam.

CAUTION: Transceiver modules can be damaged by electrostatic discharge (ESD). To prevent ESD damage to the

transceiver module, take the following precautions:

• Wear an antistatic discharge strap while handling transceiver modules.

• Place transceiver modules in antistatic packing material when transporting or storing them.

Steps

1. Position the transceiver module so that the key is oriented correctly to the port in the storage controller.

Figure 36. Install the SFP+ Transceiver Module

SFP+ transceiver module 2. Fiber-optic cable connector

2. Insert the transceiver module into the port until it is firmly seated and the latching mechanism clicks.

The transceiver modules are keyed so that they can only be inserted with the correct orientation. If a transceiver module does

not slide in easily, ensure that it is correctly oriented.

CAUTION: To reduce the risk of damage to the equipment, do not use excessive force when inserting the

transceiver module.

3. Position fiber-optic cable so that the key (the ridge on one side of the cable connector) is aligned with the slot in the

transceiver module.

Connect the Front-End Cabling