Deployment Guide

Figure 55. Wrap Label Around Cable
3. Apply a matching label to the other end of the cable.
Cabling the Embedded Ports for iSCSI Replication
If the Storage Center is licensed for replication, the replication port can be connected to an Ethernet switch and used for iSCSI
replication. If the Storage Center is licensed for replication and the Flex Port license is installed, the management port and replication
port can both be connected to an Ethernet switch and used for iSCSI replication.
Cabling the Replication Port for iSCSI Replication
If replication is licensed, the replication (REPL) port can be used to replicate data to another Storage Center.
About this task
Connect the replication port of each storage controller to an Ethernet switch through which the Storage Center can perform iSCSI
replication.
Steps
1. Connect the replication port on storage controller 1 to Ethernet switch 2.
2. Connect the replication port on storage controller 2 to Ethernet switch 2.
NOTE: The management port on each storage controller is connected to an Ethernet switch on the management
network.
Figure 56. Replication Ports Connected to an iSCSI Network
1.
Corporate/management network 2. Ethernet switch 1
3. Ethernet switch 2 (iSCSI network) 4. Storage system
5. Storage controller 1 6. Storage controller 2
3. To configure the fault domains and ports, click the Configure Embedded iSCSI Ports link on the Configuration Complete
page of the Discover and Configure Uninitialized SCv2000 Series Storage Centers wizard.
58
Connect the Front-End Cabling