Deployment Guide

Table 10. NTP, SMTP, and Proxy Servers

NTP server IPv4 address ___ . ___ . ___ . ___

SMTP server IPv4 address ___ . ___ . ___ . ___

Backup SMTP server IPv4 address ___ . ___ . ___ . ___

SMTP server login ID ________________

SMTP server password ________________

Proxy server IPv4 address ___ . ___ . ___ . ___

Fibre Channel Zoning Information

For a storage system with Fibre Channel front-end ports, record the physical and virtual WWNs of the Fibre Channel ports in Fault

Domain 1 and Fault Domain 2. This information is displayed on the Review Front-End page of the Discover and Configure

Uninitialized SCv2000 Series Storage Centers wizard. Use this information to configure zoning on each Fibre Channel switch.

Table 11. Physical WWNs in Fault Domain 1

Physical WWN of storage controller 1: port 1 ________________

Physical WWN of storage controller 2: port 1 ________________

(4-port I/O card only) Physical WWN of storage controller 1: port 3 ________________

(4-port I/O card only) Physical WWN of storage controller 2: port 3 ________________

Table 12. Virtual WWNs in Fault Domain 1

Virtual WWN of storage controller 1: port 1 ________________

Virtual WWN of storage controller 2: port 1 ________________

(4-port I/O card only) Virtual WWN of storage controller 1: port 3 ________________

(4-port I/O card only) Virtual WWN of storage controller 2: port 3 ________________

Table 13. Physical WWNs in Fault Domain 2

Physical WWN of storage controller 1: port 2 ________________

Physical WWN of storage controller 2: port 2 ________________

(4-port I/O card only) Physical WWN of storage controller 1: port 4 ________________

(4-port I/O card only) Physical WWN of storage controller 2: port 4 ________________

Table 14. Virtual WWNs in Fault Domain 2

Virtual WWN of storage controller 1: port 2 ________________

Virtual WWN of storage controller 2: port 2 ________________

(4-port I/O card only) Virtual WWN of storage controller 1: port 4 ________________

(4-port I/O card only) Virtual WWN of storage controller 2: port 4 ________________

Supported Operating Systems for Storage Center Automated Setup

Setting up a Storage Center requires 64-bit versions of the following operating systems:

• Red Hat Enterprise Linux 6 or later

Discover and Configure the Storage Center