Deployment Guide
Clean Up Test Volumes
After testing is complete, delete the volumes used for testing.
1. Connect to the server to which the volumes are mapped and remove the volumes.
2. Use the Dell Storage Manager Client to connect to the Storage Center.
3. Click the Storage tab.
4. From the Storage tab navigation pane, select the Volumes node.
5. Select the volumes to delete.
6. Right-click on the selected volumes and select Delete. The Delete dialog box opens.
7. Click OK.
Send Diagnostic Data Using Dell SupportAssist
Use Dell SupportAssist to send diagnostic data to Dell Technical Support Services.
1. Use the Dell Storage Manager Client to connect to the Storage Center.
2. In the Summary tab, click Send SupportAssist Information Now, which is located under SupportAssist Actions in the Status
pane.
The Send SupportAssist Information Now dialog box opens.
3. Select Storage Center Configuration and Detailed Logs.
4. Click OK.
5. (Optional) If the Storage Center is in maintenance mode, return it to normal operation.
Label SC100/SC120 Expansion Enclosures
SC100/SC120 expansion enclosures have do not have displays to indicate the expansion enclosure ID assigned by Storage Center.
About this task
To facilitate easy identification in the rack, use the Dell Storage Manager Client to match each expansion enclosure ID to a Service
Tag. Locate the Service Tag on the back of each expansion enclosure and then label it with the correct expansion enclosure ID.
NOTE: If an expansion enclosure is deleted from the Storage Center and then added back, the expansion enclosure is
assigned a new index number, which requires a label change.
Steps
1. Use the Dell Storage Manager Client to connect to the Storage Center.
2. Click the Hardware tab.
3. In the Hardware tab navigation pane, select the Enclosures node.
4. In the right pane, locate the enclosure to label and record the Service Tag.
5. Create a label with the enclosure ID.
NOTE: For example, if the name of the enclosure is Enclosure - 2, the enclosure ID is 2.
6. Locate the expansion enclosure with the recorded Service Tag and apply the ID label to the front left of the enclosure chassis.
Perform Post-Setup Tasks
83