Deployment Guide

Disconnect the SC100/SC120 Expansion Enclosure from the B-Side of the Chain

Disconnect the B-side cables from the expansion enclosure that you want to remove.

1. Disconnect the B-side cable (shown in blue) from expansion enclosure 1: bottom EMM, port A. The A-side cables continue to

carry I/O while the B-side is disconnected.

2. Remove the B-side cable between expansion enclosure 1: bottom EMM, port B and expansion enclosure 2: bottom EMM, port

Figure 85. Disconnecting the B-Side Cables from the Expansion Enclosure

Storage system

2. Storage controller 1

3. Storage controller 2 4. Expansion enclosure 1

5. Expansion enclosure 2

3. Connect the B-side cable to expansion enclosure 2: bottom EMM, port A.

The expansion enclosure is now disconnected and can be removed.

Adding or Removing an Expansion Enclosure