Setup Guide
Setting Up the Expansion Enclosure
Before setting up your SCv300/SCv320 expansion enclosure, consider the following best practices.
• Before connecting any cables between the storage system and expansion enclosure, physically label each port and connector.
• Always follow proper power-up and power-down procedures when cycling power across the network. Verify that critical network
components are on separate power circuits.
NOTE: This product is intended for restricted access locations, such as a dedicated equipment room or equipment closet.
WARNING: If installed in a closed or multi-unit rack assembly, the operating ambient temperature of the rack
environment may be greater than room ambient temperature. Therefore, consideration should be given to installing the
equipment in an environment compatible with the maximum ambient temperature (Tma) specied by the manufacturer.
Other Information You May Need
To install the expansion enclosure, you may need the following additional information.
NOTE: See the safety and regulatory information that shipped with your Storage Center components. Warranty
information is included as a separate document.
• The Dell Storage Center SCv3020 Storage System Deployment Guide provides information about cabling storage system
hardware components and conguring a new storage system using the Dell Storage Client.
• The Dell Storage Manager Administrator’s Guide describes how to use Dell Storage Manager to manage Storage Center
systems.
Installation and Conguration
Before you begin the installation, make sure that the site where you plan to install the expansion enclosure has standard power from
an independent source or a rack power distribution unit with a UPS.
Unpacking Storage Center Equipment
Unpack the expansion enclosure and identify the items in your shipment.
3