Setup Guide

Install the Front Bezel
Install the bezel on the front of the expansion enclosure.
1. Hook the right end of the bezel onto the expansion enclosure.
Figure 3. Front Bezel
2. Insert the left end of the bezel into the securing slot until the release latch snaps into place.
3. Secure the bezel with the keylock.
Connecting the Power Cables
Connect the power cables to the expansion enclosure.
1. Before connecting the power cables, make sure that the power switches on the expansion enclosure are in the OFF position.
2. Connect the power cables to the power supplies in the expansion enclosure chassis.
Figure 4. Power Cables
3. Secure each power cable to the expansion enclosure chassis using the strain relief fasteners.
4. Plug the other end of the power cables into a grounded electrical outlet or a separate power source such as an uninterrupted
power supply (UPS) or a power distribution unit (PDU).
NOM Information (Mexico Only)
The following information is provided on the device described in this document in compliance with the requirements of the ocial
Mexican standards (NOM):
Importer
Dell Inc. de México, S.A. de C.V
Paseo de la Reforma 2620-11 ° Piso
5