Administrator Guide

3. Click Change to open a dialog box for selecting the disks to assign to the folder.
4. Click Next.
The Create Storage Type page opens.
5. Select the redundancy level from the drop-down menu for each disk tier.
6. (Optional) Select the datapage size from the Datapage Size drop-down menu.
7. Click Next.
The Add Controller page opens.
Add a Controller (Configure Storage Center Wizard)
Configure the second controller for systems with two controllers. The Configure Storage Center Wizard automatically adds the second
controller for SC4020 Storage Centers with two controllers. You must manually configure the SC8000 Storage Center.
About this task
• If the system has only one controller, click Next to proceed to the Set System Information page.
• For SC4020 Storage Centers with two controllers, click Next to add the second controller automatically.
• For SC8000 Storage Centers with two controllers, proceed with the following steps.
Steps
1. Type a serial number for the second controller.
2. Type the IPv4 address and eth1 IPv4 address of the second controller.
3. If the first controller has an IPv6 address set and the Storage Center supports IPv6, type the IPv6 address and IPv6 subnet prefix of
the second controller.
4. Click Next. The Set System Information page opens.
Set System Information
The Set System Information page allows you to enter Storage Center and storage controller configuration information to use when
connecting to the Storage Center using Storage Manager.
Steps
1. Type a descriptive name for the Storage Center in the Storage Center Name field.
2. If the storage system is running Storage Center 7.3 or later, select the network configuration option from the Network
Configuration Source drop-down menu.
• DHCP IPv4 – Selected by default. IP addresses will be discovered and assigned.
• Static – Enter static IP addresses manually.
3. If the network configuration source is set to Static:
a) Type the system management IPv4 address for the Storage Center in the Virtual Management IPv4 Address field.
The management IPv4 address is the IP address used to manage the Storage Center and is different than a storage controller IPv4
address.
b) Type an IPv4 address for the management port of each storage controller.
NOTE: The storage controller IPv4 addresses and management IPv4 address must be within the same subnet.
c) Type the subnet mask of the management network in the Subnet Mask field.
d) Type the gateway address of the management network in the Gateway IPv4 Address field.
e) Type the domain name of the management network in the Domain Name field.
f) Type the DNS server addresses of the management network in the DNS Server and Secondary DNS Server fields.
4. Click Next.
76
Storage Center Deployment