Deployment Guide

Figure 55. Connect the B-Side Cables to the Expansion Enclosures

1. Storage system 2. Storage controller 1

3. Storage controller 2 4. Expansion enclosure 1

5. Expansion enclosure 2

2. Label the back-end cables.

Install New SCv360 Expansion Enclosures in a Rack

Install the expansion enclosures in a rack, but do not connect the expansion enclosures to the storage system. For more information, see

the SCv360 Expansion Enclosure Getting Started Guide

About this task

Steps

1. Cable the expansion enclosures together to form a chain.

a) Connect a SAS cable from expansion enclosure 1: left, port 3 to expansion enclosure 2: left, port 1.

b) Connect a SAS cable from expansion enclosure 1: right, port 3 to expansion enclosure 2: right, port 1.

c) Repeat the previous steps to connect additional expansion enclosures to the chain.

Adding or Removing Expansion Enclosures