Owners Manual
Next step
• Use Dell Storage Manager to edit the Storage Center settings and set the operation mode of the Storage Center to Production mode.
• Use Dell Storage Manager to send SupportAssist information to technical support.
Riser 1
You might need to remove a riser when replacing some of the components of an SCv3000 and SCv3020 storage system.
Observe proper electrostatic discharge precautions when replacing a riser.
Remove Riser 1
Use this procedure to remove riser 1.
Prerequisite
• Use Dell Storage Manager to send SupportAssist information to technical support.
• Use Dell Storage Manager to edit the Storage Center settings and set the operation mode of the Storage Center to Maintenance
mode.
Steps
1 Shut down the storage controller using Dell Storage Manager.
2 Make sure that all cables plugged into the storage controller are labeled.
3 Disconnect the cables from the storage controller that was shut down.
4 Remove the storage controller from the chassis.
CAUTION
: To prevent a thermal shutdown of the storage system, the service bae must be installed within three minutes
of removing the storage controller.
5 Install the service bae into the empty slot in the chassis.
6 Remove the cover of the storage controller.
7 Lift the blue latch that secures the riser to the storage controller.
8 Grasp the touch points of the riser.
9 Lift the riser from the riser connector on the system board.
10 Remove the I/O card installed in the riser and set it aside.
26
Replacing Storage System Components