Reference Guide

server showhba
Description
On Storage Center 5.0 and later, shows server port/HBA information for each attached server known to the Storage Center. Output
depends on the lter options specied.
You can run this command on Storage Centers that have the following:
• One or more precongured servers
• One or more servers that have been discovered and congured, including a mix of operational and connection status values
• One or more discovered ports that have not yet been congured (assigned to a server), including a mix of operational and connection
status values
Format
server showhba {options}
Options
–connectstatus string
Species the status of the transport connection between the server port/HBA and the Storage Center by which to lter the display. Valid
values are:
• Connected: indicates that all primary paths are up between the HBA and the Storage Center.
• Disconnected: indicates that no primary paths are up between the HBA and the Storage Center.
• Partially Connected: (requires single quotes) indicates that at least one primary path is up and at least one primary path is down
between the HBA and the Storage Center.
–csv filename
Species a csv le in which to save output.
–h
Shows help for command options.
–hbatype string
Species the transport type of the server port/HBA by which to lter the display. Valid values are:
• iSCSI
• FibreChannel
–ipaddress string
Species the IP address for the iSCSI server port/HBA by which to lter the display (iSCSI only).
–iscsi_name string
Species the unique iSCSI transport name for the server port/HBA by which to lter the display (iSCSI only).
–portinfo string
Command Reference
59