Users Guide

2. Select Actions > All Dell Storage Actions > Replications/Live Volume > Remove.
The Remove Replication or Live Volume wizard starts.
3. Select one or more replications to remove.
4. Click Next.
The Delete Options page opens.
5. Select the removal options for the replications:
● Delete Restore Point—Select this option if you want to delete the restore point for the replication.
● Recycle Destination Volume—Select this option if you want to move the destination volume to the Recycle Bin on the
destination Storage Center.
● Delete Destination Volume—Select this option if you do not want to retain the deleted destination volume in the
Recycle Bin—not recommended.
CAUTION: If you delete the destination volume, you cannot recover the volume on the destination (target)
Storage Center. The volume is permanently deleted.
6. Click Next.
The Ready to Complete page opens.
7. Click Finish.
Configure Live Volume Automatic Failover and Restore
You can enable Storage Center Automatic Failover and Automatic Restore from the vSphere Client Plugin on Live Volumes that
meet certain criteria. When Automatic Failover is enabled, the secondary Live Volume will automatically be promoted to primary
in the event of a failure. After the primary Live Volume comes back online, Automatic Restore, configured by default, restores
the Live Volume relationship.
Prerequisites
Configure a datastore Live Volume with the following attributes:
● Synchronous
● High Availability
● Protected
Steps
1. Select a datastore in the inventory for which you have configured Live Volume synchronous replication with high availability.
The vSphere Client Plugin wizard loads information for the selected datastore.
2. Select Actions > All Dell Storage Actions > Replication/Live Volume > Edit Settings/Convert.
The Modify Replication or Live Volume wizard starts.
3. Make sure the replication to modify is selected and click Next.
The Volume Settings page opens.
4. Verify that the volume settings are correct and click Next.
The Snapshot Profile page opens.
5. Verify that the correct Snapshot profile is selected and click Next.
The Replication Options page opens.
6. Make sure that the replication type selected is Live Volume, Synchronous - High Availability, and click Next.
The Live Volume Options page opens.
7. Under Live Volume Settings, select Failover Automatically. By default, Restore Automatically is also selected.
8. Click Next.
The Ready to Complete page opens.
9. Click Finish to accept the configuration, and exit the wizard.
Working With Dell Storage
25