Administrator Guide

Fault Domains in Virtual Port Mode
In virtual port mode, fault domains group front-end ports that are connected to the same Fibre Channel fabric or Ethernet network.
All ports in a fault domain are available for IO. If a port fails, IO is routed to another port in the fault domain.
The following requirements apply to fault domains in virtual port mode:
• Fault domains are created for each front-end Fibre Channel fabric or Ethernet network.
• A fault domain must contain a single type of transport media (FC or iSCSI, but not both).
CAUTION: For iSCSI only, servers initiate IO to iSCSI ports through the control port of the fault domain. If an iSCSI
port moves to a different fault domain, its control port changes. This change disrupts any service initiated through
the previous control port. If an iSCSI port moves to a different fault domain, you must reconfigure the server-side
iSCSI initiators before service can be resumed.
• For each fault domain, it is a best practice to connect at least two cables from each controller to the Fibre Channel fabric or
Ethernet network.
Fault Domains in Legacy Mode
In Legacy Mode, each pair of primary and reserved ports are grouped into a fault domain. The fault domain determines which ports
are allowed to fail over to each other.
The following requirements apply to fault domains in legacy mode on a dual-controller Storage Center:
• A fault domain must contain one type of transport media (FC or iSCSI, but not both).
• A fault domain must contain one primary port and one reserved port.
• The reserved port must be located on a different controller than the primary port.
NOTE: For a single-controller Storage Center, only one fault domain is required for each transport type (FC or
iSCSI) because there are no reserved ports.
Failover Behavior
Legacy mode, ALUA port mode, and virtual port mode behave differently during failure conditions because they use different
mechanisms to provide fault tolerance.
Scenario
Virtual Port Mode Legacy Mode ALUA Port Mode
Normal operating
conditions
All ports are active and pass IO.
• Primary ports pass IO.
• Reserved ports remain in a
standby mode until a
controller failure.
• Active/Optimized ports pass
IO.
• Standby ports remain in a
standby mode until a
controller or port failure.
A controller fails in a dual-
controller Storage Center
Virtual ports on the failed
controller move to physical ports
on the functioning controller.
Primary ports on the failed
controller fail over to reserved
ports on the functioning
controller.
Active/Optimized ports on the
failed controller fail over to
Standby ports on the functioning
controller.
A single port fails (single-
or dual-controller Storage
Center)
An individual port fails over to
another port in the fault domain.
The port does not fail over
because there was no controller
failure. If a second path is
available, MPIO software on the
server provides fault tolerance.
The port fails over to the
Standby port on the functioning
controller.
Managing Front-End IO Port Hardware
Front-end FC and iSCSI ports can be renamed and monitored with threshold definitions. iSCSI ports can be assigned network
configuration and tested for network connectivity.
NOTE: For user interface reference information, click Help.
94
Storage Center Maintenance