Administrator Guide

3 Click Next.
Customer Installation Authorization
If the storage system is running Storage Center 7.3 or later, customer authorization is required.
1 Type the customer name and title.
2 Click Next.
Set System Information
The Set System Information page allows you to enter Storage Center and storage controller conguration information to use when
connecting to the Storage Center using Storage Manager.
1 Type a descriptive name for the Storage Center in the Storage Center Name eld.
2 Select the Network Conguration Source (Storage Center 7.3 and later).
• DHCP IPv4 – Selected by default. IP addresses will be discovered and assigned.
• Static – Enter static IP addresses manually.
3 If the network conguration source is set to Static:
a Type the system management IPv4 address for the Storage Center in the Virtual Management IPv4 Address eld.
The management IPv4 address is the IP address used to manage the Storage Center and is dierent than a storage controller
IPv4 address.
b Type an IPv4 address for the management port of each storage controller.
NOTE
: The storage controller IPv4 addresses and management IPv4 address must be within the same subnet.
c Type the subnet mask of the management network in the Subnet Mask eld.
d Type the gateway address of the management network in the Gateway IPv4 Address eld.
e Type the domain name of the management network in the Domain Name eld.
f Type the DNS server addresses of the management network in the DNS Server and Secondary DNS Server elds.
4 Click Next.
Set Administrator Information
The Set Administrator Information page allows you to set a new password and an email address for the Admin user.
1 Enter a new password for the default Storage Center administrator user in the New Admin Password and Conrm Password elds.
2 Enter the email address of the default Storage Center administrator user in the Admin Email Address eld.
3 Click Next.
• For a Fibre Channel or SAS storage system, the Conrm Conguration page appears.
• For an iSCSI storage system, the Congure iSCSI Fault Domains page appears.
Conrm the Storage Center Conguration
Make sure that the conguration information shown on the Conrm Conguration page is correct before continuing. If you selected DHCP
IPv4 as the network conguration source, the dynamically assigned IP addresses are displayed on this page.
1 Verify that the Storage Center settings are correct.
2 If the conguration information is correct, click Apply Conguration.
If the conguration information is incorrect, click Back and provide the correct information.
Storage Center Deployment
79