Deployment Guide

a) In the BMC IP Address field, type an IP address for the iDRAC.

b) In the BMC Net Mask field, type the network mask.

c) In the BMC Gateway IP Address field, type the default route for the iDRAC.

5. Click OK.

6. Log in to the iDRAC and configure the iDRAC password. You will be prompted to change the iDRAC password when you log in. The

default password is root/calvin.

NOTE: Any hardware errors reported in the iDRAC can be ignored. Storage Manager is the official interface to check

hardware status.

Unconfigure Unused I/O Ports

Unconfigure a port when it is disconnected and will not be used.

Prerequisites

• The Storage Center must be a SCv3000 and SCv3020 storage system.

• The I/O port must appear as down in Storage Manager.

Steps

1. Click the Storage view.

2. In the Storage pane, select a Storage Center.

3. Click the Hardware tab.

4. In the Hardware tab navigation pane, expand Controllers >

storage controller

> IO Ports.

5. Right-click on the down I/O port and select Unconfigure Port. Storage Manager unconfigures the port.

Deploy the Storage Center