Deployment Guide

Figure 73. Reconnecting the A-Side Cable to the Remaining Expansion Enclosure

Storage system 2. Storage controller 1

3. Storage controller 2 4. Expansion enclosure 1

5. Expansion enclosure 2

Disconnect the SCv360 Expansion Enclosure from the B-

Side of the Chain

Disconnect the B-side cables from the expansion enclosure that you want to remove.

Steps

1. Disconnect the B-side cable (shown in blue) from expansion enclosure 1: right EMM, port 1. The A-side cables continue to carry I/O

while the B-side is disconnected.

2. Remove the B-side cable between expansion enclosure 1: right EMM, port 3 and expansion enclosure 2: right EMM, port 1.

Adding or Removing Expansion Enclosures