Owners Manual
Figure 17. Removing Riser 1
1
Riser 1 2 Alignment pin casings (2)
3 Alignment pins (2)
Install Riser 1
Use this procedure to install riser 1.
Prerequisite
Install the I/O card into the riser.
Steps
1 Use the alignment pegs on the board and the alignment casings on the riser to position the riser over the connector.
2 Lower the riser into place until the riser is fully seated in the connector.
3 Lower the blue latch to secure the riser to the chassis.
4 Replace the cover on the storage controller.
5 Remove the service bae from the chassis.
CAUTION
: To prevent a thermal shutdown of the storage system, the storage controller must be installed within three
minutes of removing the service bae.
6 Install the storage controller into the chassis.
7 Reconnect the cables to the storage controller.
8 Clear the storage controller swap status from the Hardware tab in Dell Storage Manager.
For instructions, see the Storage Manager Administrator’s Guide.
Replacing Storage System Components
27