Setup Guide

5 Secure the rail by installing an M5 x 16 mm screw (106-002-453) in the larger of the
two holes at the back of the rail.
6 Repeat steps 2 through 5 to install the left rail.
7 Mount the expansion enclosure chassis on the rails.
a If a mechanical lift is available, use the four handles that shipped with the
expansion enclosure to lift the expansion enclosure chassis onto a mechanical lift.
b If a mechanical lift is not available, remove the drives, cooling fans, power supply
units (PSUs), and enclosure management modules (EMMs) from the expansion
enclosure chassis and use the four handles to lift the chassis to the mounting
location.
c From the front of the rack, extend the rack rails approximately 5 to 8 cm (2 to 3
in.) and align the expansion enclosure chassis rails with the rack rails.
Figure 7. Extend the Rack Rails
d Slide the rack rails over the expansion enclosure chassis rails.
14
Setting Up the Expansion Enclosure