White Papers

5 PowerConnect 6224 or 6248 Switch Configuration
console(config-if)#exit
5. Configure LAG ports
console(config)#interface range ethernet 1/xg3,1/xg4
console(config-if)#no spanning-tree portfast
console(config-if)#channel-group 1 mode auto
console(config-if)#exit
console(config)#interface port-channel 1
console(config-if-ch1)#mtu 9216
console(config-if-ch1)#exit
console(config)#exit
console#
6. Then execute the following command to save the setup:
console#copy running-config startup-config
Repeat steps 1 through 6 for the second switch.
Note: The preceding procedure places all switch ports in the default VLAN. If you prefer to place ports in
a non-default VLAN, refer to the documentation for your switch.