White Papers

8 Array Configuration | Rapid EqualLogic Configuration Series | Implementation Guide
Once the array has restarted, close the web browser to disconnect any Group Manager session and then
open a new browser session and login again before proceeding.
3.3 Configure array controller ports
1. Select the array.
2. Open the Network tab for the member array.
Note: This figure is an example. The number of interfaces will vary depending on the array model used.
3. Double click eth1 and enter the appropriate IP address (documented in the Prerequisites section
of the preparation document from the Rapid EqualLogic Configuration Portal) and subnet mask,
then click the checkbox next to Enable this interface and click OK.