Manual

Troubleshooting 277
(VALUE)—See "Lockups and Software Problems" on page 292.
M
EMORY DOUBLE WORD LOGIC FAILURE AT (ADDRESS), READ VALUE EXPECTING
(
VALUE)—See "Lockups and Software Problems" on page 292.
M
EMORY ODD/EVEN LOGIC FAILURE AT (ADDRESS) READ VALUE EXPECTING
(
VALUE)—See "Lockups and Software Problems" on page 292.
M
EMORY WRITE/READ FAILURE AT (ADDRESS), READ VALUE EXPECTING
(
VALUE)—See "Lockups and Software Problems" on page 292.
M
EMORY SIZE IN CMOS INVALID See "Lockups and Software Problems" on
page 292.
N
O BOOT DEVICE AVAILABLESTRIKE F1 TO RETRY BOOT, F2 FOR SETUP UTILITY.
PRESS F5 TO RUN ONBOARD DIAGNOSTICSThe system cannot detect a bootable
device or partition.
• If the optical drive is your boot device, ensure that the cables are connected and that
a bootable optical media is in the drive.
• If the hard drive is your boot device, ensure that the drive is installed properly and
partitioned as a boot device.
• Enter the system setup program and ensure that the boot sequence information is
correct (see "Entering the System Setup Program" on page 308).
NO BOOT SECTOR ON HARD-DISK DRIVE Enter the system setup program and
ensure that the configuration information for the hard drive is correct (see
"Entering
the System Setup Program
" on page 308).
N
O TIMER TICK INTERRUPT Run the Dell Diagnostics (see "Running the Dell
Diagnostics" on page 281).
P
OWER WARNING MESSAGES HAVE BEEN DISABLED. RUN THE SETUP UTILITY TO
ENABLE THESE MESSAGES.—See
"Entering the System Setup Program
" on
page 308.
READ FAILURE ON INTERNAL HARD DRIVE See "Drive Problems" on page 287.
R
EAD FAILURE ON SECOND INTERNAL HARD DRIVE This message applies to
notebook computers that support multiple hard drives. See "Drive Problems" on
page 287.
RTC
MODE FIXEDTIME AND DATE MAY BE WRONG Enter the system setup
program and correct the date or time (see
"Entering the System Setup Program
" on
page 308). If the problem persists, replace the CMOS battery.
S
HUTDOWN FAILURE Run the Dell Diagnostics (see "Running the Dell
Diagnostics" on page 281).
T
IME-OF-DAY CLOCK STOPPEDPLEASE RUN THE SYSTEM SETUP