Service Manual



3. Remove the FlexDock from its packaging.



4. Gently slide the FlexDock into the FlexDock bay through the front of the computer.



5. Align the screw holes on the FlexDock with the screw holes on the drive panel.



6. Replace the two screws that secure the FlexDock to the drive panel.



7. Connect the FlexDock USB cable to the system board connector (see System Board Components).



8. Replace the front bezel (see Replacing the Front Bezel).



9. Replace the computer cover (see Replacing the Computer Cover).



10. Connect your computer and devices to electrical outlets, and then turn them on.



Removing the Filler Bracket



1. Follow the procedures in Before You Begin.



2. Remove the computer cover (see Removing the Computer Cover).



3. Remove the front bezel (see Removing the Front Bezel).



4. Gently press the tab as shown in the illustration to release the filler bracket from the front bezel.



Replacing the Filler Bracket



1. Follow the procedures in Before You Begin.



2. Align the tab in the filler bracket to the slot in the front bezel.



3. Gently press the tab and push the filler bracket to fix it to the front bezel.



breakaway metal plate

CAUTION: To comply with FCC regulations, it is recommended that you replace the filler bracket whenever the FlexDock or optical drive is

removed from the computer.

filler bracket

tab