Service Manual

Back to Contents Page
 Subwoofer
Dell™StudioXPS™1640ServiceManual
Removing the Subwoofer
Replacing the Subwoofer

Removing the Subwoofer

1. Follow the instructions in Before You Begin.

2. Remove the palm rest (see Removing the Palm Rest).

3. Disconnect the subwoofer cable from the system board connector.

4. Lift the subwoofer out of the computer base.
Replacing the Subwoofer

1. Place subwoofer in the computer base.

2. Connect the subwoofer cable to the system board connector.

3. Replace the palm rest (see Replacing the Palm Rest).
Back to Contents Page

CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™isnot
covered by your warranty.
NOTICE: To help prevent damage to the system board, remove the main battery (see Before Working Inside Your Computer) before working inside the
computer.
1
subwoofer
2
subwoofer cable connector
NOTICE: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may result in
damage to the computer.