Users Guide

16 Installing Oracle
®
RAC 10g R2 Using OCFS
Installing Patchset 10.2.0.4 for Oracle 10g Clusterware
Before You Begin
Before you install patchset 10.2.0.4 for Oracle 10g Clusterware on your system,
perform the following steps:
1
Stop nodeapps on all the nodes. Enter the following text in command
prompt:
%SystemDrive%\%CRS_HOME%\bin> srvctl stop nodeapps
-n <node name>
where %SystemDrive% is the drive on which you configured the Oracle
home and
%CRS_HOME% is the home directory that you created.
For more information on creating the home directory, see “Installing
Oracle Clusterware” on page 9.
2 Select Start → Programs → Administrator Tools → Services to start
Programs Administrator Tools Services.
3 Locate all Oracle services and stop them on both nodes.
Installing the Patchset
NOTE: You must install the patchset from the node where you installed the RAC
10g R2 software. If you are not running the OUI from the same node, exit and install
the patchset from the node where you installed the RAC 10g R2 software.
1 Start the OUI located in the patchset folder. For example:
%SystemDrive%\Oracle_patch\setup.exe
where %SystemDrive% is the drive on which you unzipped the
Oracle patchset.
2 In the Welcome window, click Next .
3 In the Specify home details window, select OraCR10g_home from the
drop-down menu and click
Next .
4 In the Specify Hardware Cluster Installation Mode window, click Next .
5 In the Product-Specific Prerequisite Checks window, click Next .