Setup Guide
Table Of Contents
- 1 Introduction
- 2 iDRAC9 Configuration for RSA SecurID
- 3 RSA SecurID 2FA with Local Users
- 4 RSA SecurID 2FA with Active Directory Users
- 5 RSA SecurID 2FA with Generic LDAP Directory Users
- 6 Troubleshooting RSA SecurID Issues
- 6.1 Misconfiguration or iDRAC Configuration Gets Reset
- 6.2 Datacenter License Expires or Gets Downgraded or Deleted
- 6.3 Authentication Failures without being Prompted for RSA Passcode
- 6.4 Authentication failures with Correct RSA Passcode
- 6.5 Authentication Failures with Correct RSA Passcode due to Timeout
- 6.6 RSA Configuration gets lost after importing Server Configuration Profile
- Appendix A: Configure iDRAC Using RACADM
- Appendix B: References
Troubleshooting RSA SecurID Issues
ID 450
racadm>> set iDRAC.Users.3.RSASecurID2FA 1
Use RACADM to enable RSA SecurID 2FA on a local user.
A.4 Enable RSA SecurID on AD Users
Run the following RACADM command to enable RSA SecurID on all AD users.
racadm>> set idrac.ActiveDirectory.RSASecurID2FAAD 1
Use RACADM to enable RSA SecurID 2FA on all AD users.
A.5 Enable RSA SecurID on LDAP Users
Run the following RACADM command to enable RSA SecurID on all LDAP users.
racadm>> set idrac.ldap.RSASecurID2FALDAP 1
User RACADM to enable RSA SecurID 2FA on all LDAP users