White Papers
14 Version 1.3.3
Table 4 – DCIM_LCEnumeration Attributes
AttributeName Description IsReadOnly PossibleValues
Licensed
Whether the
Component
Configuration Recovery
feature is
licensed.
True “Yes”, “No”
Part Configuration Update Part cofiguration update method. False
“Disabled”, “Apply
always”, “Apply only
if firmware match”
Part Firmware Update
Disable (default) = firmware update is
not allowed.
Allow version upgrade only = Allow
firmware update only on up-revision.
Match firmware of replaced part =
Always update firmware.
False
“Disable”, “Allow
version upgrade
only”, “Match
firmware of
replaced part”
Collect System Inventory on
Restart
Disabled (default) = Disable collecting
inventory on restart
Enabled = Enable collecting system
inventory on restart
False
“Disabled”,
“Enabled”
Auto Discovery
Whether Auto Discovery feature is
turned on or off.
False “On”, “Off”
Discovery Factory Defaults
Off (default) = Do not reset to factory
defaults when performing auto
discovery
On = Reset to factory defaults when
performing auto discovery.
False “On”, “Off”
IPChangeNotifyPS
On = Notify provisioning server of an IP
change.
Off = Do not notify provisioning server
of an IP change.
False “On”, “Off”
VirtualAddressManagement
Console = Console manages the virtual
addresses
FlexAddress = Virtual addresses are
managed through the flex addressing.
Note:
• If this attribute is configured
through console, refer to section
“Setting virtual address attributes
on CNA” in Simple NIC Profile.
• If its value is changed from
Console to FlexAddress, then host
server should go through two
restarts in order for this change to
be made. False
“Console”,
“FlexAddress”
7.3 DCIM_LCString
This section describes the implementation for the DCIM_LCString class.
This class shall be instantiated in the Implementation Namespace.