White Papers

85 Lifecycle Controller Integration Best Practices Guide
9 iDRAC Card Profile Use Cases
9.1 Discovery of iDRAC Card Profile Support
Use the following procedure below to confirm the existence of iDRAC Card profile support.
Applies to: LC1.5.0+
Prerequisites for script: none
Script: GetiDRACCardProfile.win
A) The Lifecycle Controller remote service must be in a “ready” state before running any other WSMAN commands.
The GetRSStatus() method or the GetRemoteServicesAPIStatus() method may be used depending on the version of the
LC Management registered profile.
B) GetLCRegisteredProfiles(): ENUMERATE the DCIM_LCRegisteredProfile class to view all registered profiles. See
section 2.2 for a definition of ENUMERATE.
C) Search for “RegisteredName=iDRAC Card” and note its instanceID to use in step D)
D) GetLCRegisteredProfile(): GET the DCIM_LCRegisteredProfile instance using the InstanceID from C). See Section
2.3 for a definition of GET.
Results for the InstanceID of DCIM:iDRACCard:1.0.0 shown below. If no instance is returned, the profile is not
supported.
DCIM_LCRegisteredProfile
AdvertiseTypeDescriptions = WS-Identify
AdvertiseTypeDescriptions = Interop Namespace
AdvertiseTypes = 1
AdvertiseTypes = 1
InstanceID = DCIM:iDRACCard:1.0.0
OtherRegisteredOrganization = DCIM
ProfileRequireLicense = Remote Firmware Configuration
ProfileRequireLicense = Remote Inventory
ProfileRequireLicense = Virtual Console
ProfileRequireLicense = Virtual Media
ProfileRequireLicense = Two-Factor Authentication