Setup Guide

Next Generation KeySecure (k170v)
32 Enable OpenManage Secure Enterprise Key Manager (SEKM) on Dell EMC PowerEdge Servers
4 Next Generation KeySecure (k170v)
4.1 Prerequisites for Next Generation KeySecure
Before you start setting up iDRAC SEKM support, you must first ensure that the following prerequisites are
fulfilled. If these prerequisites are not met, you will not be able to successfully set up SEKM.
PowerEdge Server Prerequisites
• iDRAC SEKM license installed
• iDRAC Data Center or Enterprise license
• iDRAC updated to the firmware version which supports SEKM
• PERC updated to the firmware version which supports SEKM
Thales KeySecure k170v (KMS) Prerequisites
• Configure KMIP interface
• Create a user that represents the iDRAC on the KMS
4.2 Set up SEKM on Next Generation KeySecure
This section describes the Thales KeySecure k170v features that are supported by iDRAC. For information
about all other Thales features, see the Thales Appliance Administration Guide.
4.2.1 Configure Auto-Client Registration
1. Log in to the KeySecure appliance and click KMIP (OASIS Key Management Interoperability).
Start the OSASIS Key Management Interoperability (KMIP) application
2. Click Client Profile  Add Profile.
Add Client Profiles in KMIP