Installation and Service Manual
Table Of Contents
- Dell EMC PowerEdge T440
- Dell EMC PowerEdge T440 overview
- Documentation resources
- Technical specifications
- Initial system setup and configuration
- Pre-operating system management applications
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Optional front bezel
- System feet
- Caster wheels – optional
- System cover
- Air shroud
- Drives
- Removing a drive blank
- Installing a drive blank
- Removing a drive carrier
- Installing a drive carrier
- Removing the drive from the drive carrier
- Installing a drive into the drive carrier
- Removing a 2.5 inch drive from a 3.5 inch drive adapter
- Installing a 2.5 inch drive into a 3.5 inch drive adapter
- Removing a 3.5 inch drive adapter from a 3.5 inch drive carrier
- Installing a 3.5 inch drive adapter into the 3.5 inch drive carrier
- Optical drives and tape drives
- Cabled drives
- Drive backplane
- System memory
- Cooling fans
- Optional internal USB memory key
- Expansion card holder
- Expansion cards
- Optional IDSDM or vFlash card
- Processors and heat sinks
- Power supply units
- Power interposer board
- System battery
- Control panel assembly
- System board
- Trusted Platform Module
- Converting the system from tower mode to rack mode
- Updating BIOS
- Restoring the Service Tag using Easy Restore
- Using system diagnostics
- Jumpers and connectors
- Getting help
3 Remove the expansion card holder.
Steps
1 Unpack the expansion card and prepare it for installation.
For instructions, see the documentation accompanying the card.
2 Open the expansion card latch adjacent to the slot you want to install the expansion card.
3 Remove the existing expansion card or ller bracket from the expansion card holder.
NOTE: Store this bracket for future use. Filler brackets must be installed in empty expansion-card slots to maintain FCC
certication of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airow
inside the system.
4 Holding the card by its edges, position the card so that the card aligns with the expansion card connector.
5 Insert the card rmly into the expansion card connector until the card is fully seated.
6 Close the expansion card latch by pushing the latch up until the latch snaps into place.
7 Connect the data cables to the expansion card and/or the power cables to the GPU card.
Figure 60. Removing the ller bracket
Figure 61. Installing an expansion card
Next steps
1 Follow the procedure listed in After working inside your system.
2 Install the expansion card holder.
3 Install the air shroud.
112
Installation and Service Manual
Installing and removing system components