Installation and Service Manual

Table Of Contents

Replacing the Trusted Platform Module

Prerequisites

1 Follow the safety guidelines listed in Safety instructions.

2 Follow the procedure listed in Before working inside your system.

NOTE:

• Ensure that your operating system supports the version of the TPM module being installed.

• Ensure that you download and install the latest BIOS rmware on your system.

• Ensure that the BIOS is congured to enable UEFI boot mode.

Steps

1 Locate the TPM connector on the system board.

NOTE: To locate the TPM connector on the system board, see the System board jumpers and connectors section.

2 Press to hold the module down and remove the screw using the security Torx 8-bit shipped with the TPM module.

3 Slide the TPM module out from its connector.

4 Push the plastic rivet away from the TPM connector and rotate it 90° counterclockwise to release it from the system board.

5 Pull the plastic rivet out of its slot on the system board.

6 To install the TPM, align the edge connectors on the TPM with the slot on the TPM connector.

7 Insert the TPM into the TPM connector such that the plastic rivet aligns with the slot on the system board.

8 Press the plastic rivet until the rivet snaps into place.

Figure 87. Installing the TPM

Next steps

1 Install the system board.

2 Follow the procedure listed in After working inside your system.