Installation and Service Manual
Table Of Contents
- Dell EMC PowerEdge T440
- Dell EMC PowerEdge T440 overview
- Documentation resources
- Technical specifications
- Initial system setup and configuration
- Pre-operating system management applications
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Optional front bezel
- System feet
- Caster wheels – optional
- System cover
- Air shroud
- Drives
- Removing a drive blank
- Installing a drive blank
- Removing a drive carrier
- Installing a drive carrier
- Removing the drive from the drive carrier
- Installing a drive into the drive carrier
- Removing a 2.5 inch drive from a 3.5 inch drive adapter
- Installing a 2.5 inch drive into a 3.5 inch drive adapter
- Removing a 3.5 inch drive adapter from a 3.5 inch drive carrier
- Installing a 3.5 inch drive adapter into the 3.5 inch drive carrier
- Optical drives and tape drives
- Cabled drives
- Drive backplane
- System memory
- Cooling fans
- Optional internal USB memory key
- Expansion card holder
- Expansion cards
- Optional IDSDM or vFlash card
- Processors and heat sinks
- Power supply units
- Power interposer board
- System battery
- Control panel assembly
- System board
- Trusted Platform Module
- Converting the system from tower mode to rack mode
- Updating BIOS
- Restoring the Service Tag using Easy Restore
- Using system diagnostics
- Jumpers and connectors
- Getting help
Chassis weight
Table 10. Chassis weight
System conguration Maximum weight
4 x 3.5 inch drive system 23.9 Kg (52.69 lb)
8 x 3.5 inch drive system 29.5 Kg (65.03 lb)
16 x 2.5 inch drive system 27.7 Kg (61.06 lb)
Processor specications
The PowerEdge T440 system supports up to two Intel Xeon Processor Scalable Family processors.
PSU specications
The PowerEdge T440 system supports the following AC redundant power supply units (PSU).
Table 11. PSU specications
PSU Class Heat dissipation
(maximum)
Frequency Voltage
1100 W AC Platinum 4100 BTU/hr 50/60 Hz 100–240 V AC, autoranging
750 W AC Platinum 2891 BTU/hr 50/60 Hz 100–240 V AC, autoranging
495 W AC Platinum 1908 BTU/hr 50/60 Hz 100–240 V AC, autoranging
NOTE: This system is also designed to connect to the IT power systems with a phase to phase voltage not exceeding 230 V.
System battery specications
The PowerEdge T440 system supports CR 2032 3.0-V lithium coin cell system battery.
Expansion bus specications
The PowerEdge T440 system supports ve PCI express (PCIe) generation 3 expansion cards.
Memory specications
The PowerEdge T440 system supports DDR4 registered DIMM slots (RDIMMs) and load-reduced DIMM slots (LRDIMMs). Supported
memory bus frequencies are 1866 MT/s, 2133 MT/s, 2400 MT/s, and 2666 MT/s.
CPU1 supports up to 10 DIMM slots and CPU 2 supports up to 6 DIMM slots.
26
Installation and Service Manual
Technical specications